No-Dog Nível de compensação Verde - Elimina as pernas de cachorro em deslocamentos e selas por não-cão

The No-Dog is a handy tool for electricians that eliminates "dog-legs" in offsets and saddles. It is precision tooled from lightweight, durable aluminum. Measuring 1/2" by 1" by 2", it is useful as a spacer with multiple runs of conduit. This size also makes it convenient to carry. The "No-Dog" can fit easily in a pocket or tool box, or can be clipped to a hardhat or tool pouch. The No-Dog offset level is proudly made in the USAHow to use your No-Dog offset level 1. Position conduit in bender. 2. Attach "No-Dog" to conduit at either end as shown below. Do not move "No-Dog" until all the bends are finished to insure that all bends will be on the same plane. 3. Adjust bender pressure on conduit so conduit is snug yet loose enough to be turned with a pair of channelloks, pipe wrench or chain wrench. 4. Turn conduit until "No-Dog" shows level. 5. Bend conduit to desired angle. 6. Release bender pressure. 7. Turn conduit 180 degrees and position at next bend mark. 8. Repeat steps 3 and 4. 9. Make next bend. 10. For additional bends on same plane, repeat steps 6, 7, 8, and 9.What's included? 1 - No-Dog offset level 1 - No-Dog hard hat sticker 1 - Offset formula and fraction to decimal conversion chart

• The No-Dog is a handy tool for electricians that eliminates "dog-legs" in offsets and saddles.
• It is precision tooled from lightweight, durable aluminum.
• Measuring 1/2" by 1" by 2", it is useful as a spacer with multiple runs of conduit.
• The "No-Dog" can fit easily in a pocket or tool box, or can be clipped to a hardhat or tool pouch.
• The No-Dog offset level is proudly made in the USA